A model-free crown is designed and milled without a physical model. That saves a step, but the checks a model used to give you now happen in software. This post goes through the three that 3Shape's own guide points to: the cement gap, the contacts and the dynamic occlusion. It also covers what to send when a design partner designs the crown for you.
It is written for lab owners and CAD/CAM technicians. It covers design settings and files, not clinical decisions. The 3Shape guidance here comes from 3Shape's 3 step guide to making model free crowns with Dental System, published in 2014. Menus have changed since then, so this post keeps to the principles and leaves out menu steps.
1. Tune the cement gap to your mill and material
- It is specific to your setup. 3Shape's guide says: "You will need to tune the cement-gap parameters to your specific milling machine and material."
- Test a few versions. The guide suggests that you "design and mill at least 3 versions of the crown with varying cement-gap settings" and compare them.
- Test again after a change. In the guide's words: "Naturally, you will need to test again if you invest in a new machine or use another material."
2. Design to the contacts
Without a model, there is no stone contact to check against. 3Shape's guide says to "design and control the crown in relation to your mesial and distal contact points." Decide how strong you want the contacts once, then check each design against that.
3. Check dynamic occlusion in the virtual articulator
The guide is direct about occlusion: "Since we are working without a model, you must always control dynamic occlusion using the software Virtual Articulator." Static contacts alone do not show how the crown behaves in movement.
When a design partner designs your model-free crowns
The values you tune for your mill and material are the values your design partner needs.
- Send your preferences once. SubDesignCenter keeps each lab's design preferences on file (contact strength, occlusal clearance, cement gap and minimum thickness) and applies them to that lab's cases. If you retune after a new machine or material, send the new values.
- Name the material and the mill on each ticket. Designs are prepared for the material named on your work ticket.
- What comes back. SubDesignCenter delivers editable 3Shape design files plus production-ready files for your mill or printer.
- Scans. For crowns and bridges, send the prep, opposing and bite scans. Scans from any intraoral or desktop scanner are accepted as STL, PLY or OBJ files.
For the full list of what to agree before a first case, see how to run three free test cases for 3Shape crown design outsourcing.
Checklist
- Cement gap tuned for each mill and material you use
- At least 3 test crowns milled with different cement-gap settings
- Retest planned for any new machine or material
- Contacts designed and checked against your mesial and distal contact points
- Dynamic occlusion checked in the virtual articulator
- Tuned values (cement gap, contact strength, occlusal clearance, minimum thickness) sent once to your design partner
- Material and mill named on every ticket
Try it on three cases
New labs can send SubDesignCenter three free test cases: crowns, or bridges of up to 3 units, including implant bridges. To see prices, open the price list on our pricing page. Questions about your workflow? Reach us through the contact section on our site.